Installed front and rear license plates and license plate lighting

Made a new belly plate, turned out really well.

Exterior mirrors in place.

I made a template for the small side windows for the front doors and had them made. Now they are also installed. I’m just missing the scraper strips for the larger door windows. I’ve been looking but haven’t managed to find and buy any new scraper strips yet.

Have installed the door seal on the left front door now, so now all door seals are new on the bus.

Can recommend using masking tape and spending a little extra time when installing the door seal. You will not get any spills and the result will be very good.

I felt like I needed to do something else for a while so I started fixing the grill on the car.

The guy who did the rust repair on the car and removed all the door handles also did some work on the front of the car. The bottom part of the grill is welded and integrated with the bumper. When I took over the car, the rest of the grill was missing but I managed to get a pretty nice grill that I was going to use.

I have started rebuilding the grill so that it will fit. Cut off the bottom part, welded end plates on. Welded the holes for the chrome strip.

Also made four new countersunk holes for the upper screws that hold the grill.

The next step will be to make three guide pins for the lower part of the grill.

Going to visit a paint store to see if they can mix up some more paint that I need for the car.